Ledvance FL 200 PCELL P 133W 840 20KLM PSBK

Floodlight with daylight sensor, up to 20000 lm. Product properties: Daylight sensor integrated into the glass cover. Switches on below 35 Lux, switches off above 95 Lux illuminance. High luminous efficacy: up to 150 lm/W. Degree of protection: IP66. Pre-installed, flexible cable (H05RN-F) with 1 m length, 3 x 1.0 mm² crimped. Reflector-based, symmetrical light distribution with 100° x 100° beam angle. Mounting bracket with 30° angle and large rotation range. Integrated voltage driver, suitable for 220 - 240 V AC. Product advantages: Automatic switching on and off depending on daylight. Continuous operation possible, activation by means of special switching scheme. Climate membrane for optimized air exchange, with constantly high degree of IP protection. Very versatile due to a wattage setting selectable on the housing (Multi Lumen). Robust cable gland with integrated Waterstop function. Safe and very uniform illumination, thanks to opaque, tempered glass diffuser. Light output, robust and long-lasting. No light emission in the upper hemisphere (ULOR 0%) at 0° inclination. Energy saving of up to 90 % compared to halogen floodlights. Areas of application: Replacement for floodlights with halogen lamps. Outdoor use (IP66). D-mark according to EN 60598-2-24 for hazardous locations, e.g. due to dust accumulation. Public space. Illumination of facades. Construction sites. Parking lots. Safety instructions: Max. wind load area 0.085 m².
Suitable for surface mounting: Yes, Suitable for recessed mounting: No, Wall mounting: Yes, Suitable for pendant suspension: No, Suitable for ceiling mounting: No, Suitable for truss mounting: No, Suitable for podium/floor mounting: Yes, Suitable for track mounting: No, Suitable for clamp mounting: No, Suitable for cable system: No, Adjustability: swivel, With motion detector: No, With light sensor: Yes, Lamp: LED non-replaceable, With lamp: Yes, Suitable for number of lamps: 0, Socket: none, Material of the housing: aluminum, Surface: powder-coated, Housing color: black, Brushed surface: No, Type of voltage: AC, Rated voltage: 220-240V, Rated current: 590-519mA, Control gear: EVG, With control gear: Yes, Replaceable control gear: No, Dimming 0-10 V: No, Dimming 1-10 V: No, Dimming DALI-2: No, Dimming DALI: No, Dimming DMX: No, Dimming DSI: No, Dimming potentiometer (device-integrated): No, Dimming LineSwitch: No, Dimming manufacturer-specific: No, Dimming mains voltage modulation: No, Dimming phase section: No, Dimming phase cut: No, Dimming programmable: No, Dimming RF: No, Dimming Sine Wave Reduction: No, Dimming Touch and Dim: No, Dimming Zigbee: No, Dimming with push-button: No, Without dimming function: Yes, Reflector: matte, Light distributor: reflector, Light distribution: symmetrical, Light exit: direct, Energy efficiency class of the light source according to EU Directive 2019/2015: not required, Rated life L70/B50 at 25 °C: 100000h, Constant light output control: No, Degree of protection (IP): IP66, Impact resistance: IK08, Protection class: I, Rated ambient temperature according to IEC62722-2-1: -30-50°C, Max. system power: 133.00W, Light color: white, Color temperature: 4000K, Color rendering index CRI: 80-89, Luminous flux: 20000lm, Rated luminous flux according to IEC 62722-2-1: 20000lm, Power factor: 0.90, Adjustable color temperature: no, Adjustable luminous flux: no, Adjustable radiation angle: no, Width: 58.00mm, Height/Depth: 376.00mm, Length: 294.00mm, Type of wiring: Terminal, Number of poles: 3, Connection type: Terminal block, Light fitting with limited surface temperature D-mark: Yes, Max. number of light fittings circuit breaker B16: 4, Integrated emergency power supply: No, Light fitting luminous efficacy: 150lm/W, Photobiological safety according to EN 62471: RG1, Suitable for VDU workstations according to EN 12464-1: No, Covering the light fitting with thermal insulation material possible: No, IFTTT support available: Yes, Color consistency (McAdam ellipse): SDCM